Installation of GAN products – video installation and photos

Our engineers have been working tirelessly on making GAN devices easy to manage and install. Harness the performance potential of your car! In most cases, you can install GAN products yourself in less than 15 minutes.

GAN GT/GTL Installation

16 EASY STEPS

Download the GAN app from the App Store for iOS or from Google Play for Android.

Turn off the ignition, remove the key and wait 5 minutes.

Open the bonnet and remove the engine cover, as shown by way of the Audi А6 1.8Т 190 hp.

Locate the sensors that are relevant for installation in your vehicle. Connection points are marked with arrows.

Remove the plug from the first sensor.

Connect the corresponding harness socket to the first sensor and the disconnected plug. Make sure that the plugs are clicked into place. The GAN device is now connected to the first sensor.

Remove the plug from the second sensor.

Connect the corresponding harness socket to the second sensor and the disconnected plug. Make sure that the plugs are clicked into place. The GAN device is now connected to the second sensor.

Connect the GAN GT device to the big plug on the harness.

Fasten the GAN GT device and the cable at a suitable point using the cable ties.

Mount the engine cover. Close the bonnet.

Start the engine.

Connect to your GAN in the application. Use the last 6 digits of the device’s serial number as a password.

Select your car in the application. The necessary settings will then be sent to the device.

Choose between DYNAMIC, ECO or STOCK (OFF) mode on your smartphone.

Feel your car in a new way!

GAN GA+ Installation

10 EASY STEPS

Download the GAN app from the App Store for iOS or from Google Play for Android.

Warm up your engine to operating temperature (90°C).

Find the OBD-II connector in your vehicle; it is usually located under the steering wheel. You will find the exact location of the OBD-II connector in the installation guide for your car.

Plug the device into the OBD-II connector when the engine is running.

Connect to your GAN in the application. Use the last 6 digits of the device’s serial number as a password.

Select your car in the application. The necessary settings will then be sent to the device.

Calibration begins once the settings have been downloaded; this takes 3 minutes. A red LED will flash during calibration and you can check the calibration status on your smartphone. Once the calibration is finished, the LED will turn yellow to show the device is working.

A 120 km drive is required before the device adapts to the engine control unit.

Choose between DYNAMIC, ECO and STOCK (OFF) mode on your smartphone.

Feel your car in a new way!

10 EASY STEPS

Download the GAN PC app under INSTALLATION.

Connect the device to your PC with a Micro USB cable.

Select your car in the application. The necessary settings will then be sent to the device.

GAN is ready to be installed in your vehicle.

Warm up your engine to operating temperature (90°C).

Find the OBD-II connector in your vehicle; it is usually located under the steering wheel. You will find the exact location of the OBD-II connector in the installation guide for your car.

Plug the device into the OBD-II connector when the engine is running.

A 120 km drive is required before the device adapts to the engine control unit.

Feel your car in a new way!

INSTALLING GAN PRODUCTS